前其提要：消費者要求在手環（c型/開口型）內側客製化雷射雕刻特定文字，且要求位置
落在手環的邊邊（接近開口處）
翻譯內容：關於雷射的位置，我們無法將雷射打在手環的邊邊（接近開口處），因為手環
的開口太小，雷射的激光（直線光）穿過去時只能打在中間。
求檢查下列翻譯是否正確！
Regarding to the place, we can't put the laser on the edge of bangle because o
f the opening of cuff is too small that the rays leaving the laser don't go th
rough. Can we put the laser inside in the middle of bangle( see photo attached
) ?

應該可以只求語意而已吧?我會這樣翻:

請問若再補：please see the photo attached(the logo ismarked red that you can easy to see)（我在照片上面 用紅色標記起來 容易理解）

Regarding the position for laser engraving,the bracelet's gap does not allow the laser beamallow the laser beam to reach either sides of theeither sides (ends) but to the center part of thebracelet. Therefore we are not able to engravethe demanded letters close to the edge of theinner side close to the bracelet's gap.(Please refer to the attached picture.the position of the logo is marked in red.)抱歉，不太會用PTT，不過意思應該是這樣吧?給您參考!

謝謝。好專業！

不會!